Removing the engine from the installation position

• When lowering the engine, guide the engine mount (1) into the front subframe.
• Make sure that the plastic on the engine mount (1) is not damaged when removing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lower the engine by 10 mm by rotating spindle 2 361 506 (00 6 103) .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Engine mount to front axle support
  M8	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten bolt (1) of the right engine mount using a commonly available tool.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Engine mount to engine support bracket
  M12	Tightening torque	100 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install right bracing strut (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Engine mount reinforcement strut on front, front subframe
  M12x25	Tightening torque	108 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Engine mount reinforcement strut on body
  M12x120	Tightening torque	108 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Detach hook on the engine mounting brackets.
• Carefully remove engine bridge with help from an assistant.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
• Refer to INSTALLING REAR SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to INSTALLING THE CROSSING OF THE TRANSMISSION WIRING HARNESS .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING LEFT STRUT BRACE .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE CENTER COWL UPPER PART .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR HOOD SEAL .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .