Installing the crossing of the transmission wiring harness
- Guide in and position the crossing of the transmission wiring harness.
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATION
Crossing of the transmission wiring harness to the cylinder head cover M6x16 Tightening torque 10 Nm - Clip transmission wiring harness into clamps (1).
- Fix clip (3) of injection valve wiring harness/cylinder 1 to 4 ignition wiring harness in crossing of transmission wiring harness (4).
- Clip primary oxygen sensor cable into clamp (1).
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATION
Crossing of the transmission wiring harness to the cylinder head cover M6x16 Tightening torque 10 Nm - Clip in the transmission wiring harness from clamps (3).
- Position the holder of gasoline particulate filter sensors (2) with centering lugs (1) on the crossing of transmission wiring harness (3).
- Tighten the screws (3).TIGHTENING TORQUE SPECIFICATION
Holder of the gasoline particulate sensor to the crossing of the transmission wiring harness Screw M6x16 Tightening torque 10 Nm - Connect connectors (1) and lock.
- Connect connectors (2) and lock.
- Clip transmission wiring harness (5) into clamp (4).
- Clip tank ventilation line (2) into clamp (1).