Install the stiffening plate
- Feed in the thrust field (4) in the area of the wheel arch trim panel and position it on the front subframe.
- Replace the bolts (arrows).
Parts : Screws
- Tighten screws (arrows).TIGHTENING TORQUES SPECIFICATION
Thrust field to front axle support M10
Replace screws.Snug torque 56 N m Angle of rotation 90° - Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Cover, steering unit Thermoplastic hexagon screw Tightening torque 2.6 Nm - Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Wheel arch cover Thermoplastic hexagon screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm - Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Undershield/frame Hexagon screw Tightening torque 3 Nm