Installing acoustic cover
NOTE:
RISK OF DAMAGE
Damage to the acoustic cover/design cover.
Jerky movements during disassembly and application of excessive force during installation may result in breakage of the acoustic cover/design cover.
Damage to the acoustic cover/design cover.
Jerky movements during disassembly and application of excessive force during installation may result in breakage of the acoustic cover/design cover.
- Disassemble or mount the acoustic cover/design cover carefully.
- Disassemble or mount snap-lock couplings of the ball pivots one after the other.
- Disassemble or mount the acoustic cover/design cover only at temperatures > 20°C.
- Use only distilled water as an auxiliary material during installation, no lubricants.
- Check the detent pin (2) for damage and replace the acoustic cover if necessary.
- Check the acoustic cover for a correct fit of the rubber mount (1).
- Check rubber mount (1) for correct fit.
- Check the detent pin (2) for damage and replace if necessary.
- Clip in the acoustic cover (1) into the holder.