Tighten the bolts on the front axle support
- Replace screws (1) to (3).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Front axle carrier to body, rear M14
Replace screw.Joining torque 100 Nm Angle of rotation 90° - Tighten screws (2).TIGHTENING TORQUE SPECIFICATIONS
Front axle support to center of body M12
Replace screw.Tightening torque 100 Nm Angle of rotation 90° - Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Front axle carrier to body, front M12
Replace screw.Joining torque 100 Nm Angle of rotation 90° NOTE: Perform the steps on the right and left side. - Replace screws (1).
Parts: screw
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bottom bumper bracket on the front subframe . | ||
| M8 Replace screws. |
Tightening torque | 19 Nm |
Follow-up work
- Refer to SECURING THE WISHBONE ON THE TOP LEFT AND RIGHT ON THE SWIVEL BEARING .
- Refer to REMOVING THE MOBILE LIFTING TABLE .
- Refer to FASTENING COOLANT HOSE TO THE FRONT SUBFRAME .
- Refer to SECURING THE TRANSMISSION OIL COOLING BRACKET .
- Refer to SECURING LEFT AND RIGHT SPRING STRUT HOLDERS ON THE LOWER WISHBONE .
- Refer to FASTENING THE BRAKE HOSE AND THE CABLE ON THE LEFT AND RIGHT .
- Refer to CONNECTING THE CONNECTOR TO THE LEFT AND RIGHT VERTICAL ACCELERATION SENSOR .
- Refer to FASTENING THE RIGHT AND LEFT OUTPUT SHAFTS ONTO THE WHEEL BEARING .
- Refer to SECURING THE UNIVERSAL JOINT ON THE STEERING GEAR .
- Refer to ATTACHING THE WIRING HARNESS OF THE ACTIVE STABILIZER .
- Refer to FASTENING WIRING HARNESS TO THE EPS .
- Refer to IF INSTALLED: FASTEN THE AUXILIARY HEATER .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT CRASH LEVER .
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT, BOTTOM LEFT AND RIGHT .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to TAKING ENGINE OUT OF INSTALLATION ORIENTATION .