Installing the coolant feed line for the left exhaust turbocharger
- Replace the screw (1)
.
Parts: Screw
- Replace the sealing ring or sealing rings (2)
.
Parts: Sealing ring or sealing rings
When installing sealing rings without an installation aid (bar), both sealing rings must be replaced.
- Position screw (1)
with sealing ring or sealing rings (2)
on the coolant line.
- Position coolant feed line (2) .
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant lines on exhaust turbocharger | ||
|---|---|---|
| Screw M14x1.5 | Tightening torque | 15 Nm |
| Angle of rotation | 75° | |
- Tighten down screw (4) .
TIGHTENING TORQUE SPECIFICATIONS
| Holders for coolant lines at exhaust turbocharger | ||
|---|---|---|
| M6x16 screw | Tightening torque | 8 Nm |
- Tighten hose clamp (1) .
Follow-up work
- Refer to INSTALLING THE LEFT OIL FEED LINE PARTIALLY .
- Refer to INSTALLING HEAT SHIELD, TOP .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 5 TO 8 .
- Refer to INSTALLING THE CROSSING OF THE TRANSMISSION WIRING HARNESS .
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE .
- Refer to INSTALLING BRACKET FOR RIGHT INTAKE SILENCER .
- Refer to INSTALLING OIL FILLER NECK .
- Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 1 .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
- Refer to INSTALLING THE ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
- Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
- Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE LOWERING LEFT FRONT WHEEL ARCH COVER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .