Installing the crossing of the transmission wiring harness
- Guide in and position the crossing of the transmission wiring harness.
- Tighten down screw (2)
.TIGHTENING TORQUES SPECIFICATION
Crossing of the transmission wiring harness to the cylinder head cover M6x16 tightening torque 10 Nm - Clip the transmission wiring harness into clamps (1) .
- Fix clip (3) of the wiring harness of the fuel injection valves/ignition of cylinders 1 to 4 in the crossing of transmission wiring harness (4) .
- Clip the cable of the Lambda oxygen sensor into clamps (1) .
- Tighten down screw (2)
.TIGHTENING TORQUES SPECIFICATION
Crossing of the transmission wiring harness to the cylinder head cover M6x16 tightening torque 10 Nm - Clip in the transmission wiring harness from clamps (3) .
- Position the holder of gasoline particulate filter sensors (2)
with centering lugs (1)
on the crossing of transmission wiring harness (3)
.
- Tighten the screws (3)
.TIGHTENING TORQUES SPECIFICATION
Holder of gasoline particulate sensor to the crossing of the transmission wiring harness Screw M6x16 tightening torque 10 Nm - Connect connectors (1) and lock.
- Connect connectors (2)
and lock.
- Clip transmission wiring harness (5) into clamps (4) .
- Clip tank vent line (2)
into clamps (1)
.