Installing the oil-level sensor
Prepare the oil-level sensor
- Replace sealing ring (1).
Parts: Sealing ring
- Insert and install the oil-level sensor (2).
- Tighten the nuts (arrows).TIGHTENING TORQUES SPECIFICATION
Oil-level sensor to oil sump M6 Joining torque 2.5 Nm Tightening torque 8.5 Nm - Connect and lock the connector (1).
The connector (1) must engage audibly.
- Feed in the cover (1) in the marked area and install.
Follow-up work
- Refer to RAISING THE FRONT AXLE SUPPORT AND FASTEN IT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT
- Refer to INSTALLING REAR SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING WHEEL ARCH TRIM, FRONT RIGHT .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING COVER ON EXHAUST SYSTEM .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to REMOVING THE OIL FILLER CAP
- Refer to TOPPING UP THE MOTOR OIL
- Refer to INSTALLING THE OIL FILLER CAP
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to TAKING ENGINE OUT OF INSTALLATION ORIENTATION .