Installing front propeller shaft at the front axle transmission
- Before installing the prop shaft on the front axle transmission, all the 4 threads (1)
in the drive flange must be cleaned and free from possible residues and contaminations.
- Replace screws.
Parts: Screws
- A drop of Loctite 270 (2)
must be given before the screw connection on each thread at the end of the respective screw (1)
.
Consumable High-strength screw lock, Loctite 270 10 ml, Tube 83 192210 337 NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again. - Tighten screws (arrows).TIGHTENING TORQUES SPECIFICATION
Prop shaft before the front axle differential Replace screws.
Joining torque and angle of rotation must be observed without fail.Tightening torque 25 Nm Angle of rotation 45°
Follow-up work
- Refer to INSTALLING THE TRANSFER BOX (ATC 13-1) .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to IF INSTALLED: SCREWING DOWN TRANSMISSION SUPPORT BRACKET .
- Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
- Refer to INSTALLING THE RETAINING PLATES .
- Refer to INSTALLING THE HEAT SHIELDS .
- Refer to INSTALLING STARTER MOTOR .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to IF INSTALLED: INSTALLING THE REAR AXLE COVER .
- Refer to INSTALLING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .