Bevel Box, Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
Install in the reverse order of removal while noting the following:
-- Place the bevel box with the right flange shaft on the transmission while turning the flange shaft at the same time.
-- Tighten the bevel box on the transmission.
-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING 2.0L or FAN SHROUD, REMOVING AND INSTALLING 2.0L DIESEL .
-- Gear Oil, Checking Level. Refer to GEAR OIL, CHECKING LEVEL .
Tightening Specifications
- Refer to OVERVIEW - BEVEL BOX
- Refer to BEVEL BOX, TIGHTENING SPECIFICATION
- Refer to OVERVIEW - DIFFERENTIAL
- Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- Refer to OVERVIEW - DRIVE AXLE .
- Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
- Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .
- Refer to OVERVIEW - DRIVESHAFT .
- Refer to OVERVIEW - NOISE INSULATION .