Overview - Differential
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 30 Nm
- Right Flange Shaft
- For Front Wheel Drive (FWD) vehicles. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Bolt
- 33 Nm
- Right Flange Shaft
- For All Wheel Drive (AWD) vehicles
- Removing and installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Seal
- Always replace after removing
- Insert into the surrounding right flange shaft groove
- Remove to replace the needle bearing (polygon bearing) -6-
- Needle Bearing (Polygon Bearing)
- If it is difficult to move when the flange shaft is removed, this is not a fault
- Acoustic test only when installed
- Check for damage, for example for cracks on the bearing outer race
- Replacing. Refer to RIGHT FLANGE SHAFT NEEDLE BEARING (POLYGON BEARING), REPLACING .
- Circlip
- Always replace after removing
- Bevel Box
- Bolt
- 30 Nm
- Left Flange Shaft
- Removing and installing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Transmission