Overview - Assembly Mounts
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 2.
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 40 Nm +90°
- Bolt
- Replace after removing
- 20 Nm +90°
- Bolt
- Replace after removing
- 40 Nm +90°
- Bolt
- Replace after removing
- 60 Nm +90°
- Pendulum Support
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolts
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- 60 Nm +90°
- Bolt
- Replace after removing
- 60 Nm +90°
- Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 50 Nm + 90°
- Bolt
- Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT .
- Transmission Support
- For vehicles with manual transmission
- Bolt
- Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT .
Engine Support - Tightening Specification and Sequence
-- Tighten the bolts in steps in the tightening sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | 7 Nm |
| 2. | -1 to 3- | 40 Nm |
| 3. | -1 to 3- | 180° additional turn |
Installing the pendulum support
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -2 and 3- | 50 Nm |
| 2. | -1- | 130 Nm |
| 3. | -1 to 3- | 90° additional turn |