Section 24 (6-Speed Manual Transmission 0A3, All Wheel Drive)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- 00 Technical data
- 30 Clutch
- Clutch mechanism, servicing
- Clutch mechanism, servicing
- Pedal cluster, assembly overview
- Clutch Pedal Switch F36, removing and installing
- Over-center spring, removing and installing
- Hydraulic system, assembly overview
- Clutch master cylinder and slave cylinder, notes on removing and installing
- Clutch master cylinder, removing and installing
- Hydraulic clutch system, bleeding
- Clutch release mechanism, servicing
- Clutch, servicing
- Clutch mechanism, servicing
- 34 Controls, housing
- Shift mechanism, servicing
- Transmission, removing and installing
- Transmission gear oil, checking level
- Transmission mounting, removing and installing
- Mounting transmission on assembly stand
- Transmission cover and Torsen differential, removing and installing
- Transmission cover, dismantling and assembling
- Transmission cover, dismantling and assembling
- Notes
- Pressing out flange shaft (transmission cover with vibration damper)
- Pressing out flange shaft (transmission cover without vibration damper)
- Pressing in flange shaft
- Levering off the oil seal.
- Preparing oil seal for installation
- Drive in seal onto stop.
- Pressing out ball bearing for flange shaft
- Pressing in ball bearing for flange shaft
- Transmission cover, dismantling and assembling
- Selector shaft with selector cylinder, servicing
- Reversing light switch, removing
- 35 Gears, shafts
- 39 Final drive, differential