Clutch release lever, removing and installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Release Lever Remove/Install Components

GW00019159

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Loosen bolt - 1 - and remove leaf spring - 2 -.
Remove clutch release lever - 3 - with release bearing.
Disengage retaining tabs of release bearing at release lever.

Installing

Before installing clutch release lever, apply a thin coat of copper grease Z381351TE to contact surface for operating rod of clutch slave cylinder.
Install clutch release lever - 3 - with release bearing onto guide sleeve.
Install leaf spring - 2 - and tighten new bolt - 1 - to 24Nm.