LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle, Drive Shafts - Removal, Replacement And Installation) >> Drive Shaft, CV Joint (Ambulance; 2003-2004) >> Boot, half shaft, replacing >> Disassembly >> For cleaning/assembly and greasing the outer joint, see below

For cleaning/assembly and greasing the outer joint, see below

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Clamp From Inner Gaiter
GLL109786Courtesy of VOLVO CARS OF NORTH AMERICA.
NOTE: The joint can be cleaned when assembled and blown clean before greasing. See Lubricate the constant velocity joint thoroughly . For disassembly and inspection, see Mark the outer constant velocity joint outer ring, ball holder and inner ring , Remove the ball bearings , Remove the ball bearing holder and the inner ring from the shaft , Wash the constant velocity joint components thoroughly  and Install the inner ring in the ball holder . For greasing, see Lubricate the constant velocity joint thoroughly . To install the boot and joint, see Replace the snap ring , Install the new boot/boots on the drive shaft , Apply grease in the boot  and Vent the boot .
scientia non olet · About LEMON Manuals