LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle, Drive Shafts - Removal, Replacement And Installation) >> Drive Shaft, CV Joint (Ambulance; 2003-2004) >> Boot, half shaft, replacing >> Reassembly >> Apply grease in the boot

Apply grease in the boot

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Applying Grease In Boot
GLL109791Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply the remaining grease from Lubricate the constant velocity joint thoroughly .

NOTE: Ensure that there is no grease on the mating surfaces between the boot and the constant velocity joint and the shaft.

Remove excess grease. Use methylated spirit.

Ensure that the boot is in position on the constant velocity joint housing.

Install a new clamp. Use pliers 9512619 .

scientia non olet · About LEMON Manuals