Section 219 (Carrier Plate - Removal And Installation)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Mechanical
- Replacing the carrier plate
- Notes
- Removal
- Installation
- Removing the transmission
- Notes
- Disconnecting the battery lead
- Removing engine compartment components
- Removing the upper torque rod
- Continue removing engine compartment components
- Removing the torque control arm
- Removing the transmission cable from the lever and the screws for the cable bracket on the transmission
- Removing the mounting screws for the transmission / starter motor
- Installing the lifting hook, part 1
- Installing the lifting hook, part 2
- Installing the lifting beam and lifting hook on the engine
- Removing the air baffle and splash guard under the engine
- Draining the transmission fluid
- Removing the nuts and screws for the steering gear sub-frame
- Hanging up the steering gear in a tie strap. Use the hole in the body
- Removing the screws for the cable conduit and ground lead bracket on the sub-frame
- Removing the nut for the lower ball joint / control arm
- Removing the control arms and tie rod (both sides)
- Removing the screws from the sub-frame support plates (both sides)
- Removing the wheel spindle from the control arm
- Removing the drive shaft from the wheel spindle (right-hand side)
- Removing the cap for the drive shaft support bearing
- Removing the drive shaft
- Press up the sub-frame on the right-hand side
- Removing the charge air pipe for the turbocharger (TC) under the engine
- Removing the screws for the torque rod from the transmission
- Removing the screw from the starter motor and the exhaust pipe from the turbocharger (TC)
- Removing the front cross member
- Removing the screw for the rear engine pad
- Removing the rear engine mounting
- Preparatory work for removing the wheel spindle on the left-hand side
- Removing the left drive shaft from the transmission
- Lowering the sub-frame
- Lowering the engine and transmission
- Removing the collision protection system over the steering gear
- Removing the 6 screws for the torque converter
- Removing the screw for the transmission / engine
- Preparations for removal of the transmission
- Installing the fixture on the mobile jack and the transmission
- Removing the transmission
- Check
- Replacing the carrier plate