Installing the carrier plate
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ensure that the mating surfaces on the crankshaft and carrier plate are completely clean.
Install the carrier plate and the two washers. The washer between the crankshaft flange and the carrier plate is completely flat.
The washer under the screw heads has a dome which must point towards the transmission.
Use new screws.
The carrier plate can only be installed in one way.
Install gear sector 9995112 .
Tighten the screws crosswise. Tighten to 60 Nm . Then angle-tighten all 10 screws crosswise. Tighten to 90°.
Remove counterhold 9995112