Removing The Clamp From The Inner Boot (If The Boot Is Being Replaced)

Fig 1: Clamp From Inner Gaiter

GLL109786

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the boot and remove it from the shaft.

NOTE:

The outer constant velocity joint can be cleaned while assembled. For checking and cleaning see Cleaning / checking the outer constant velocity joint .

NOTE:

The inner constant velocity joint can be cleaned while assembled and blown clean prior to greasing.

To disassemble the joint, see Clean and mark up the constant velocity joint , Separate the shaft and pull out the inner joint and Checking and inspection .

To Assemble And Lubricate The Outer Joint:

See Installing The Inner Ring In The Ball Holder , Lubricating The Constant Velocity Joint , Replacing The Circlip , Installing The New Boots On The Drive Shaft , Greasing The Boot and Venting The Boot .