Overview - Input Shaft
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Warm the toothed gear to approximately 100 °C (212 °F) using :VAS6414 . Wear protective gloves.
Install all input shaft bearings with transmission fluid.
Replace grooved ball bearing -item 4- after removing.
- Circlip
- For grooved ball bearing/input shaft
- Removing and installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Determining a new thickness. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING
- Transmission Housing
- Circlip
- Select when replacing the grooved ball bearing and the input shaft. Refer to Selecting the Circlip
- Grooved Ball Bearing
- Replace after removing
- Removing. Refer to Input Shaft, Disassembling .
- Installation position. Refer to Grooved Ball Bearing Installation Location and Installing the Grooved Ball Bearing .
- Installing. Refer to Grooved Ball Bearing Installation Location and Installing the Grooved Ball Bearing .
- 5th Gear
- Available as a replacement part together with the input shaft
- Removing. Refer to Removing the 5th Gear Wheel .
- Installed position: the surrounding groove -arrow- points toward grooved ball bearing
- Installing. Refer to Input Shaft, Assembling .
- Input Shaft
- With 3rd/4th and 6th gear wheel
- Cylindrical Roller Bearing
- With circlip
- Removing. Refer to Removing the Cylindrical Roller Bearing from the Clutch Housing .
- Installing. Refer to Pressing Cylindrical Roller Bearing into Clutch Housing. .
- Installed position: the circlip in bearing points to input shaft
- Clutch Housing