Overview - Input Shaft, Output Shafts, Differential, Gearshift Rods

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Output Shaft 1st through 4th Gear
   • Disassembling and Assembling. Refer to OUTPUT SHAFT, 1ST TO 4TH GEARS, DISASSEMBLING AND ASSEMBLING .
   • Installation position. Refer to  19.
2. Gearshift Rod with Shift Fork for 1st Gear and 2nd Gear
   • Installation position. Refer to  19.
3. Gearshift Rod with Shift Fork for 3rd Gear and 4th Gear
   • Installation position. Refer to  19.
4. Output Shaft for 5th/6th and Reverse Gears
   • Disassembling and Assembling. Refer to OVERVIEW - OUTPUT SHAFT, 5TH/6TH AND REVERSE GEARS .
   • Installation position. Refer to  19.
5. Gearshift Rod with Shift Fork for 5th Gear and 6th Gear
   • Installation position. Refer to  19.
6. Reverse Gear Shift Fork
   • Installation position. Refer to  19.
7. Input Shaft
   • Installation position. Refer to  19.
   • Disassembling and Assembling. Refer to OVERVIEW - INPUT SHAFT .
   • Replace grooved ball bearing on drive axle after removing. Refer to OVERVIEW - INPUT SHAFT .
8. Thrust Washer
   • Place on the reverse shaft
9. Reverse Shaft
10. Thrust Washer
11. Bleeder
    • Connect with clutch slave cylinder
12. Clutch Housing
    • Servicing. Refer to OVERVIEW - CLUTCH HOUSING .
13. Input Shaft Seal
    • Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
14. O-Ring
    • Install on the line connection
    • Coat with brake fluid before installing
15. Clutch Slave Cylinder with Release Bearing
16. Bolt
    • Quantity: 3
    • Replace after removing
    • Tightening specification. Refer to OVERVIEW - CLUTCH RELEASE MECHANISM .
17. Bolt
    • Tightening specification. Refer to OVERVIEW - DIFFERENTIAL .
18. Right Flange Shaft
    • With pressure spring and tapered ring
    • Removing and Installing. Refer to RIGHT SEAL, REPLACING .
    • Assembling. Refer to OVERVIEW - DIFFERENTIAL .
19. Differential
    • Disassembling and Assembling. Refer to OVERVIEW - DIFFERENTIAL .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 - Input Shaft

2 - Output Shaft 1st through 4th Gear

3 - Output shaft for 5th/6th and reverse gears

4 - Reverse Shaft

A - 3rd and 4th Gear Gearshift Rod

B - 1st and 2nd Gear Gearshift Rod

C - 5th and 6th Gear Gearshift Rod

D - Reverse Gear Shift Fork

The Reverse Gear Shift Fork -D- is Mounted on the 5th and 6th Gear Gearshift Rod -C-.