Section 264 (Final Drive, Differential - 5-Speed Manual Transmission 0A4 (As Of 04.2010))
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
- 39 Final Drive, Differential
- General Information
- Description And Operation
- Specifications
- Removal And Installation
- Disassembly And Assembly
- Differential
- Notes
- Removing the Outer Race/Tapered Roller Bearing from the Clutch Housing
- Installing the Outer Race/Tapered Roller Bearing into the Clutch Housing
- Removing the Bearing Inner Race/Taper Roller Bearing
- Installing the Bearing Inner Race/Taper Roller Bearing
- Removing the Outer Race/Tapered Roller Bearing from the Transmission Housing
- Installing the Outer Race/Tapered Roller Bearing into the Transmission Housing
- Differentiating the Spring Pins
- Allocation, Differential Housing
- Roll Pin with Groove (short roll pin): Removing and Installing
- Removing the Spring Pin without Surrounding Groove (long spring pin): Removing the Differential Bevel Gear Axle
- Spring Pin without Surrounding Groove (long spring pin), Installing
- On Some Transmissions, the Thrust Washer Union has a Ridge -A-
- Installing the Differential Planetary Gears and Differential Bevel Gear Axle
- Installed Position: Tapered Ring Thrust Washer -1-
- Differential
- Special Tools