Spring Pin without Surrounding Groove (long spring pin), Installing
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
-- Align the hole in the differential bevel gear axle to the hole in the differential housing.
-- Install the new adapter sleeve to dimension -a- = 3.0 mm using a mandrel -1-.
- The spring pin must not come in contact with the transmission when the differential housing is installed.