LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Prius Plug-In Hybrid SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (1 Of 2) >> Hood Lock Control Cable Assembly >> Removal [12/2022 - 03/2023] >> Procedure

Removal [12/2022 - 03/2023]: Procedure

  1. REMOVE RADIATOR SUPPORT OPENING COVER 

    Refer to PROCEDURE - Step 3

  2. REMOVE INLET NO. 1 AIR CLEANER (for M20A-FXS) 

    Refer to PROCEDURE - Step 4

  3. REMOVE HOOD LOCK ASSEMBLY 
    1. GTY1159213Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Hood Lock Bolt - -
      1. Disengage the clamp and disconnect the connector.
      2. Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.
      3. Remove the 2 bolts and hood lock bolt.
      4. Disconnect the hood lock control cable and lever set to remove the hood lock assembly.
  4. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 10

  5. REMOVE COWL SIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 11

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. GTY1141023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. GTY1156654Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT TIRE LH 

    Refer to PROCEDURE - Step 2

  10. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH 
    Refer to PROCEDURE - Step 1
  11. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  12. REMOVE FRONT FENDER LINER LH 

    Refer to PROCEDURE - Step 4

  13. REMOVE HOODLOCK CONTROL CABLE & LEVER SET 
    1. GTY1156655Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals