LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display - Service Information (Except Hybrid) >> Combination Meter >> Installation [06/2017 - ] >> Procedure

Installation [06/2017 - ]: Procedure

  1. INSTALL COMBINATION METER ASSEMBLY 
    1. Connect each connector.
    2. Engage the clamp.
    3. Engage the 2 clips as shown in the illustration.
      GTY748575Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
    4. Install the combination meter assembly with the 3 screws.
  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    1. Connect the connector.
    2. Engage the 2 guides and 4 clips as shown in the illustration.
      GTY742445Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
    3. Install the 2 clips.
    4. Engage the 4 clips and 2 claws to install the instrument cluster finish panel assembly.
      GTY757163Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
  3. INSTALL NO. 2 METER HOOD CLUSTER 

    Refer to PROCEDURE - Step 27 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 30 [10/2020 - ]

  4. INSTALL NO. 1 METER HOOD CLUSTER 

    Refer to PROCEDURE - Step 13 [06/2017 - 09/2019] , or refer to PROCEDURE - Step 12 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 12 [03/2020 - ]

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - ]

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

scientia non olet · About LEMON Manuals