Front Suspension Member: Removal

REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT:

Remove engine assembly with transaxle (See REMOVAL ).
REMOVE NO. 1 FRONT STABILIZER BRACKET LH (See REMOVAL )
REMOVE NO. 1 FRONT STABILIZER BRACKET RH
HINT:

Perform the same procedure as the LH side.
REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
REMOVE POWER STEERING LINK ASSEMBLY (See REMOVAL )
INSTALL ENGINE HANGERS (See REMOVAL )
REMOVE FRONT FRAME ASSEMBLY (See REMOVAL )
REMOVE TRANSVERSE ENGINE MOUNTING INSULATOR (See REMOVAL )
REMOVE FRONT LOWER SUSPENSION ARM LH (See REMOVAL )
REMOVE FRONT LOWER SUSPENSION ARM RH
HINT:

Perform the same procedure as the LH side.
REMOVE FRONT SUSPENSION MEMBER DYNAMIC DAMPER
1. Remove the 2 bolts and front suspension member dynamic damper.
  
  Fig 1: Identifying Front Suspension Member Dynamic Damper Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER
REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER
REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION
1. Install SST as shown below.
  SST 09830-10010 (09830-01010, 09830-01040, 09830-01050), 09950-40011 (09951-04020, 09952-04010, 09955-04011)
  
  Fig 2: Identifying SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, remove the front suspension member body mounting front cushion.
  NOTE:
  - Make sure that the claws of SST are securely hung onto the mounting cushion.
  - Tighten SST slowly and evenly.
  - Be careful as the mounting cushion may fly out.
  - The mounting cushion cannot be reused.
  Fig 3: Using SST To Remove Front Suspension Member Body Mounting Front Cushion
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH
1. Using SST, remove the front suspension member body mounting rear cushion LH.
  SST 09830-10010 (09830-01010, 09830-01040, 09830-01050), 09950-40011 (09951-04020, 09952-04010, 09954-04010, 09955-04011)
  NOTE:
  - Make sure that the claws of SST are securely hung onto the mounting cushion.
  - Tighten SST slowly and evenly.
  - Be careful as the mounting cushion may fly out.
  - The mounting cushion cannot be reused.
  Fig 4: Using SST To Remove Front Suspension Member Body Mounting Rear Cushion LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION RH
HINT:

Perform the same procedure as the LH side.

SST 09830-10010 (09830-01010, 09830-01040, 09830-01050), 09950-40011 (09951-04020, 09952-04010, 09954-04010, 09955-04011)