Transmission Control Cable: Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Hatchback) (See REMOVAL )
- REMOVE CONSOLE BOX ASSEMBLY REAR (for Hatchback) (See REMOVAL )
- REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan) (See REMOVAL )
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Sedan) (See REMOVAL )
- REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See REMOVAL )
- REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan) (See REMOVAL )
- REMOVE CONSOLE BOX CARPET (for Sedan) (See REMOVAL )
- REMOVE REAR CONSOLE BOX ASSEMBLY (for Sedan) (See REMOVAL )
- DISCONNECT OXYGEN SENSOR CONNECTOR
- REMOVE EXHAUST PIPE ASSEMBLY FRONT (See REMOVAL )
- REMOVE FRONT FLOOR HEAT INSULATOR NO.1
- Remove the 2 bolts and nut and remove floor heat insulator No. 1.
- REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
- Disconnect the control shift cable from the shift lever.
- Turn the lock to release it and separate the control shift cable from the shift lever retainer.
- Remove the clip and disconnect the control select cable from the shift lever.
- Turn the lock to release it and separate the control select cable from the shift lever retainer.
- Remove the 2 clips and the 2 washers, and disconnect the 2 cables from the transaxle.
- Remove the 2 clips and disconnect the 2 cables from the control cable bracket.
- Remove the 3 nuts and remove the transmission control cable.