REAR CONSOLE BOX (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
1. Remove the shift lever knob.
  
  Fig 1: Identifying Shift Lever Knob Sub-Assembly (For Manual Transaxle)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
1. Shift the shift lever into the N position.
2. Disengage the 5 clips and the claw and remove the upper console panel.
  
  Fig 2: Identifying Upper Console Panel Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
1. Disengage the 3 clips and 3 claws.
2. Disconnect the connector and remove the console upper rear panel.
  
  Fig 3: Identifying Console Upper Rear Panel Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CONSOLE BOX CARPET
1. Remove the console box carpet.
  
  Fig 4: Locating Console Box Carpet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR CONSOLE BOX ASSEMBLY
1. Disconnect the clamp.
2. Remove the 2 bolts and 2 screws.
3. Disengage the 4 claws and remove the rear console box.
  
  Fig 5: Locating Rear Console Box Bolts & Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002