COMBINATION METER (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER
1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
  
  Fig 1: Identifying Instrument Panel Finish Panel Lower Center Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.
  
  Fig 2: Identifying Instrument Panel Finish Panel End LH Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end RH.
  
  Fig 3: Identifying Instrument Panel Finish Panel End RH Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT CLUSTER FINISH PANEL
1. Disengage the 7 claws and 5 clips and remove the instrument cluster finish panel.
  
  Fig 4: Identifying Instrument Cluster Finish Panel Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Disconnect the 2 connectors.
2. Remove the 2 screws and pull the combination meter rearward to remove it.
  
  Fig 5: Identifying Combination Meter Assembly Screws And Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002