Inspection Procedure

1. Check if the CAN communication system DTC is output (see DTC CHECK/CLEAR  ).

Result: 

1. B: REPAIR CAN COMMUNICATION SYSTEM (SEE  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
2. A: Go to next step. 

1. Check if the multiplex communication system DTC is output (see DTC CHECK/CLEAR ).

Result: 

1. B: REPAIR MULTIPLEX COMMUNICATION SYSTEM (SEE  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
2. A: Go to next step. 

1. Connect the hand held tester to the DLC3.
2. Start the engine.
3. Select "ACTIVE TEST" on the hand held tester.

   ACTIVE TEST: ABS/VSC 

   ACTIVE TEST - ABS/VSC
   
   

   Item	Vehicle Condition/Test Details	Diagnostic Note
   VSC WARN LIGHT	Turn VSC warning light ON/OFF	Observe combination meter

4. Check that "ON" and "OFF" of the VSC warning light are indicated on the combination meter when using the hand held tester.

   OK: 

   The VSC warning light turns on or off in accordance with the hand held tester. 

1. NG: Go to step 4 
2. OK: REPLACE ABS & TRACTION ACTUATOR ASSY (SEE  REPLACEMENT  ) 

HINT:

If troubleshooting has been carried out according to the problem symptoms table, refer back to the table and proceed to the next step before replacing the part (see PROBLEM SYMPTOMS TABLE ).

1. Check the combination meter assy (see HOW TO PROCEED WITH TROUBLESHOOTING ).

1. NG: REPLACE COMBINATION METER ASSY (SEE  OVERHAUL  ) 
2. OK: END 

HINT:

If troubleshooting has been carried out according to the problem symptoms table, refer back to the table and proceed to the next step (see PROBLEM SYMPTOMS TABLE  ).