| ABS does not operate BA does not operate EBD does not operate |
- Check the DTC again and make sure that the normal system code is output (if a trouble code is output, see page 05-578)
- IG power source circuit
- Speed sensor circuit
- Check the ABS & TRACTION actuator assy with the hand-held tester (Check ABS & TRACTION actuator assy operation using the active test function) If abnormal, check the hydraulic circuit for leakage
- If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the ABS & TRACTION actuator assy (skid control ECU)
|
| ABS does not operate efficiently BA does not operate efficiently EBD does not operate efficiently |
- Check the DTC again and make sure that the normal system code is output (if a trouble code is output, see page 05-578)
- Speed sensor circuit
- Stop light switch circuit
- Check the ABS & TRACTION actuator assy with the hand-held tester (Check ABS & TRACTION actuator assy operation using the active test function) If abnormal, check the hydraulic circuit for leakage
- If the symptoms still occur even after the above circuits In suspected areas are inspected and proved to be normal, replace the ABS & TRACTION actuator assy (skid control ECU)
|
| VSC and/or TRACTION does not operate |
- Check the DTC again and make sure that the normal system code is output (If a trouble code is output, see page 05-578)
- IG power source circuit and ground circuit.
- Check the hydraulic circuit for leakage
- Speed sensor circuit
- Yaw rate/Deceleration sensor circuit
- Steering sensor circuit
- If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the ABS & TRACTION actuator assy (skid control ECU)
|
| ABS sensor DTC check cannot be done |
- Check the DTC again and make sure that the normal system code is output (If a trouble code is output, see page 05-578)
- TC and CG terminal circuit
- If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the ABS & TRACTION actuator assy (skid control ECU)
|
| VSC sensor DTC check cannot be done |
- Check the DTC again and make sure that the normal system code is output (If a trouble code is output, see page 05-578)
- TC and CG terminal circuit
- If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the ABS & TRACTION actuator assy (skid control ECU)
|
| Sensor signal check cannot be done |
- TS and CG terminal circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| ABS warning light abnormal (Remains on) |
- ABS warning light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| ABS warning light abnormal (Does not come on) |
- ABS warning light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| VSC warning light abnormal (Remains on) |
- VSC warning circuit
- ABS & TRACTION actuator assy {skid control ECU)
|
| VSC warning light abnormal (Does not come on) |
- VSC warning light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| BRAKE warning light abnormal (Remains on) |
- BRAKE warning light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| BRAKE Warning light abnormal (Does not come on) |
- BRAKE warning light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| SLIP indicator light abnormal (Remains on) |
- SLIP indicator light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| SLIP indicator light abnormal (Does not come on) |
- SLIP indicator light circuit
- ABS & TRACTION actuator assy (skid control ECU)
|
| Skid control buzzer abnormal |
- Skid control buzzer circuit
- ABS & TRACTION actuator assy (skid control ECU)
|