How To Proceed With Troubleshooting

HINT:

• Use this procedure to troubleshoot the multiplex communication system.

1. VEHICLE BROUGHT TO WORKSHOP 
   1. NEXT: Go to next step. 
2. DTC CHECK (See  DTC CHECK/CLEAR  ) 
   1. Check for DTCs and note any codes that are output.
   2. Delete the DTCs.
   3. Recheck for DTCs. Try to reproduce the DTC by simulating the original activity that the DTC suggests.
      1. If the DTC does not reoccur, proceed to A.
      2. If the DTC reoccurs, proceed to B.
   1. B: Go to step   4 
   2. A: Go to next step. 
3. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU (see TERMINALS OF ECU )
4. ADJUST, REPAIR OR REPLACE 
   1. NEXT: Go to next step. 
5. CONFIRMATION TEST 
   1. NEXT: END