LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle & Differential (6MT)) >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission assembly from the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MANUAL TRANSMISSION ASSEMBLY>REMOVAL .
  2. Remove the transfer case together with the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>REMOVAL .
  3. Remove the transmission case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSMISSION CASE>REMOVAL .
  4. Remove the drive pinion shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>DRIVE PINION SHAFT ASSEMBLY>REMOVAL .
  5. Remove the main shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MAIN SHAFT ASSEMBLY>REMOVAL .
  6. Remove the front differential assembly.
    CAUTION:
    • Do not confuse the right and left taper roller bearing outer races.
    • Be careful not to damage the oil seal of differential side retainer.
    G08318991Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the differential side retainers using the ST.

    Preparation tool: 

    ST: WRENCH COMPL RETAINER (18658AA021)

    G13604312Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the taper roller bearing outer race from the transmission case using the ST (PULLER ASSY).
scientia non olet · About LEMON Manuals