LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Continuously Variable Transaxle (CVT) (H6DO)) >> Front Reduction Drive Gear >> Installation

Front Reduction Drive Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the mating surface of converter case cover and converter case.
  2. Select the shim for front reduction drive gear. Ref. to ADJUSTMENT , Front Reduction Drive Gear.
  3. Apply CVTF to the shims and install on the bearing catch surface of the front reduction drive gear.
  4. Install the seal ring to converter case cover.
    NOTE:
    • Use new seal rings.
    • When installing the seal rings, do not expand the seal rings too much.
    Fig 1: Identifying Seal Rings
    G09482326Courtesy of SUBARU OF AMERICA, INC.
  5. Install the front reduction drive gear and front reduction driven gear together.
    CAUTION: Be careful not to detach the spline of input clutch and the spline of front reduction driven shaft.
    Fig 2: Identifying Front Reduction Drive Gear And Driven Gear
    G09482339Courtesy of SUBARU OF AMERICA, INC.
  6. Install the converter case cover. Ref. to INSTALLATION , Converter Case Cover.
  7. Install the oil pump chain cover and the oil pump chain. Ref. to INSTALLATION , Oil Pump Chain.
  8. Install the drive pinion shaft assembly. Ref. to INSTALLATION , Drive Pinion Shaft Assembly.
  9. Install the primary pulley, secondary pulley and variator chain. Ref. to INSTALLATION , Primary Pulley and Secondary Pulley.
  10. Install the transmission case. Ref. to INSTALLATION , Transmission Case.
  11. Install the forward clutch assembly. Ref. to INSTALLATION , Forward Clutch Assembly.
  12. Install the intermediate case. Ref. to INSTALLATION , Intermediate Case.
  13. Install the transfer reduction driven gear assembly. Ref. to INSTALLATION , Transfer Reduction Driven Gear.
  14. Install the transfer clutch assembly. Ref. to INSTALLATION , Transfer Clutch.
  15. Install the rear drive shaft. Ref. to INSTALLATION , Rear Drive Shaft.
  16. Install the extension case. Ref. to INSTALLATION , Extension Case.
  17. Install the primary speed sensor. Ref. to INSTALLATION , Primary Speed Sensor.
  18. Install the transmission harness. Ref. to INSTALLATION , Transmission Harness.
  19. Install the control valve body and oil pan. Ref. to INSTALLATION , Control Valve Body.
  20. Install the air breather hose. Ref. to INSTALLATION , Air Breather Hose.
  21. Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
scientia non olet · About LEMON Manuals