LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle & Differential (TY85) (WRX-STI)) >> Driven Gear Assembly >> Installation

Driven Gear Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Adjust the main shaft snap ring. < Ref. to ADJUSTMENT , Main Shaft Assembly. >
  2. Adjust the 1st-2nd fork rod. < Ref. to ADJUSTMENT , Shifter Fork and Rod. >
  3. Install the thrust needle bearing.
    NOTE: Confirm that the thrust needle bearing is installed in the proper direction.
    Fig 1: Installing Thrust Needle Bearing
    G05003417Courtesy of SUBARU OF AMERICA, INC.
  4. Install the 1st needle bearing.
  5. Install the driven gear assembly. < Ref. to INSTALLATION , Main Shaft Assembly. >
  6. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  7. Adjust the backlash of the driven gear assembly in the axial direction. < Ref. to ADJUSTMENT , Driven Gear Assembly. >
  8. Install the center differential. < Ref. to INSTALLATION , Center Differential. >
  9. Install the transfer driven gear. < Ref. to INSTALLATION , Transfer Driven Gear. >
  10. Install the extension case. < Ref. to INSTALLATION , Extension Case. >
  11. Install the neutral position switch, back-up light switch and harness. < Ref. to INSTALLATION , Neutral Position Switch. > < Ref. to INSTALLATION , Back-up Light Switch. >
  12. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals