LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle & Differential (TY85) (WRX-STI)) >> Neutral Position Switch >> Installation

Neutral Position Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the neutral position switch.
    NOTE: Use a new gasket.

    Tightening torque: 

    32 A/m (3.3 kgf-m, 23.6 ft-lb) 

  2. Connect the connector and clip of the neutral position switch.
  3. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals