Driven Gear Assembly: Adjustment

WARNING: This page is about a different variant/trim than selected.

Measure the length "H" from the transmission case and transfer bearing holder mating surface, to the end face of the ball bearing.

Fig 1: Measuring Length H From Transmission Case And Transfer Bearing Holder Mating Surface
Courtesy of SUBARU OF AMERICA, INC.

Using the following calculation, calculate the thickness of the driven gear assembly adjusting washer.

T = H - {5.8±0.05 mm (0.23±0.002 in)} - {0.1 - 0.3 mm (0.0039 - 0.0118 in)}

T	Adjusting washer thickness
H	Length from the transmission case and transfer bearing holder mating surface to the end face of the ball bearing
5.8±0.05 mm (0.23±0.002 in)	Collar thickness
0.1 - 0.3 mm (0.0039 - 0.0118 in)	Driven gear assembly axial direction backlash standard

Select 0 to 3 adjusting washers from the following table, and adjust to the backlash that is closest to the standard value.

Driven gear assembly axial direction backlash standard:

0.1 - 0.3 mm (0.0039 - 0.0118 in)