Preparation for Overhaul: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine assembly from the body. Ref. to REMOVAL , Engine Assembly.
Set the engine on ST.
ST 18232AA000 ENGINE STAND

Fig 1: Setting Engine On ST
Courtesy of SUBARU OF AMERICA, INC.
Before servicing overhaul, remove the sensor, pipe and hose that installed to engine.
1. Remove the intake manifold. Ref. to REMOVAL , Intake Manifold.
2. Remove the generator. Ref. to REMOVAL , Generator.
3. Remove the A/C compressor. Ref. to REMOVAL , Compressor.
4. Disconnect the water pipe and hose.
5. Disconnect the engine harness.
6. Remove the spark plug. Ref. to REMOVAL , Spark Plug.
7. Remove the camshaft position sensor. Ref. to REMOVAL , Camshaft Position Sensor.
8. Remove the crankshaft position sensor. Ref. to REMOVAL , Crankshaft Position Sensor.
9. Remove the knock sensor. Ref. to REMOVAL , Knock Sensor.
10. Remove the engine coolant temperature sensor. Ref. to REMOVAL , Engine Coolant Temperature Sensor.
11. Remove the oil temperature sensor. Ref. to REMOVAL , Oil Temperature Sensor.
12. Remove the oil flow control solenoid valve. Ref. to REMOVAL , Oil Flow Control Solenoid Valve.
13. Remove the oil pressure switch. Ref. to REMOVAL , Oil Pressure Switch.
14. Remove the oil filter. Ref. to REMOVAL , Engine Oil Filter.
15. Remove the oil cooler. Ref. to REMOVAL , Oil Cooler.