LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System - Fuel Injection (Fuel Systems) (H6DO - 3.6L DOHC)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Locating Front And Rear Side Holding Position
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Drain engine coolant. Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
  4. Disconnect the connectors from the engine coolant temperature sensor.
    Fig 2: Identifying Engine Coolant Temperature Sensor Connectors
    G06651227Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals