LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Lubrication System - Lubrication (H6DO - 3.6L DOHC)) >> Oil Cooler >> Removal

Oil Cooler: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.
  1. Lift up the vehicle.
  2. Remove the under cover. Ref. to REMOVAL , Front Under Cover.
  3. Drain engine coolant. Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
  4. Drain the engine oil. Ref. to REPLACEMENT , Engine Oil.
  5. Remove the bolts which hold the engine oil cooler water pipe to chain cover and disconnect the water hose from oil cooler.
    Fig 1: Locating Engine Oil Cooler Bolts
    G06651562Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the engine oil filter using the ST. Ref. to REMOVAL , Engine Oil Filter. ST 18332AA020 OIL FILTER WRENCH
  7. Remove the oil cooler connector and remove the oil cooler.
    Fig 2: Identifying Oil Cooler Connector And Oil Cooler
    G06651563Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals