LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (H6DO) >> Rear Chain Cover >> Removal

Rear Chain Cover: Removal

NOTE: Perform the work with the engine installed to body when replacing a single part.
  1. Remove the V-belts. <Ref. to REMOVAL , V-belt .>
  2. Remove the crank pulley. <Ref. to REMOVAL , Crank Pulley .>
  3. Remove the front chain cover. <Ref. to REMOVAL , Front Chain Cover .>
  4. Remove the timing chain. <Ref. to REMOVAL , Timing Chain Assembly .>
  5. Remove the cam sprocket. <Ref. to REMOVAL , Cam Sprocket .>
  6. Remove the crank sprocket. <Ref. to REMOVAL , Crank Sprocket .>
  7. Remove the oil pump. <Ref. to REMOVAL , Oil Pump .>
  8. Remove the water pump. <Ref. to REMOVAL , Removal, Water Pump .>
  9. Remove the rear chain cover.
    NOTE: Installation bolt has seven different sizes. To prevent the confusion in installation, keep these bolts on container individually.
    Fig 1: Identifying Rear Chain Cover Bolt Location
    G05345804Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals