Preparation for Overhaul: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine assembly from the body. < Ref. to REMOVAL , Engine Assembly. >
Set the engine on ST.
ST 18232AA000 ENGINE STAND

Fig 1: Identifying ST 18232AA000 Engine Stand
Before servicing overhaul, remove the sensor, pipe and hose that installed to engine.
1. Remove the intake manifold. < Ref. to REMOVAL , Intake Manifold. >
2. Remove the generator. < Ref. to REMOVAL , Generator. >
3. Remove the A/C compressor. < Ref. to REMOVAL , Compressor. >
4. Disconnect the water pipe and hose.
5. Disconnect the engine harness.
6. Remove the spark plug. < Ref. to REMOVAL , Spark Plug. >
7. Remove the camshaft position sensor. < Ref. to REMOVAL , Camshaft Position Sensor. >
8. Remove the crankshaft position sensor. < Ref. to REMOVAL , Crankshaft Position Sensor. >
9. Remove the knock sensor. < Ref. to REMOVAL , Knock Sensor. >
10. Remove the engine coolant temperature sensor. < Ref. to REMOVAL , Engine Coolant Temperature Sensor. >
11. Remove the oil pressure switch. < Ref. to REMOVAL , Oil Pressure Switch. >
12. Remove the oil filter. < Ref. to REMOVAL , Engine Oil Filter. >
13. Remove the oil cooler. < Ref. to REMOVAL , Oil Cooler. >