LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) >> Compressor >> Removal

HVAC System (Heater, Ventilator And A/C): Compressor: Removal

  1. Perform the compressor oil return operation. < Ref. to PROCEDURE , Compressor Oil. >
  2. Turn the A/C switch to OFF and stop the engine.
  3. Using the refrigerant recovery system, discharge refrigerant. < Ref. to PROCEDURE , Refrigerant Recovery Procedure. >
  4. Disconnect the ground cable from battery.
  5. Remove the V-belts. < Ref. to REMOVAL (H4SO) , V-belt. > < Ref. to REMOVAL (H4DOTC) , V-belt. > < Ref. to REMOVAL (H6DO) , V-belt. >
  6. Remove the generator. < Ref. to REMOVAL , Generator. >
  7. Remove the bolt and remove the low-pressure hose and high-pressure hose.
    Fig 1: Locating Low-Pressure Hose And High-Pressure Hose Bolts
    G05020390
  8. Disconnect the compressor harness from body harness.
  9. Remove the bolts and remove the compressor bracket.
    • H4 model
      Fig 2: Locating Compressor Bracket Bolts - H4 Model
      G05020391
    • H6 model
      Fig 3: Locating Compressor Bracket Bolts - H6 Model
      G05020392
  10. Remove the bolts, then remove the bracket from the compressor.
    Fig 4: Locating Compressor Bracket Bolts
    G05020393
scientia non olet · About LEMON Manuals