LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Fuel Injection (Fuel Systems) (H6DO)) >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  3. Remove the generator harness from fuel pipe protector LH.
  4. Remove the fuel pipe protector LH.
    Fig 2: Locating Fuel Pipe Protector LH Bolts
    G05018408
  5. Disconnect the connector from camshaft position sensor LH.
    Fig 3: Locating Camshaft Position Sensor LH Connector
    G05018443
  6. Remove the camshaft position sensor LH.
    Fig 4: Locating Camshaft Position Sensor LH
    G05018444
  7. Remove the camshaft position sensor RH in the same procedure as LH.
scientia non olet · About LEMON Manuals