Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Secure the shift control cable grommet by pressing the cable into the pass-thru hole in the cowl.
- Ensure that the shift control range select lever is in the park (P) position.
- Install the shift control cable to the shift control.
- Install the shift control cable onto the shift control range select lever pin.
- Install the right side console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
- Install the console trim plate. Refer to Console Trim Plate Replacement .
- Install the center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
- Install the shift control lever knob. Refer to Transmission Control Lever Knob Replacement .
- Install the shift control cable (2) to the shift control cable bracket (3). Ensure the shift control cable retaining tabs fully engage the shift control cable bracket.
- Connect the shift control cable (1) to the transaxle range switch lever (4).
- Adjust the shift control cable. Refer to Shift Control Cable Adjustment .
- Install the battery tray. Refer to Battery Tray Replacement .
- Enable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
- Release the parking brake.
IMPORTANT:
Ensure the shift control cable is routed exactly as originally positioned in the vehicle to avoid coming into contact with potential hazards such as hot, sharp, and moving objects.