Head Up Display (HUD) - (With Diagnostics)
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Trouble In HUD Power Supply System (Communication With The Scan Tool (M.U.T.-IIISE) Is Not Possible.)
- Inspection Procedure 2: The Combiner Does Not Work, Open Or Close Normally Even If Combiner Open/Close Switch Is Operated
- Inspection Procedure 3: The Position Of The Combiner Display Area Cannot Be Adjusted Even If The Angle Adjustment Switch Is Operated
- Inspection Procedure 4: The Position Of The Combiner Display Area Cannot Be Adjusted Even If The Angle Adjustment Switch Is Operated
- Inspection Procedure 5: Nothing Is Displayed In The Combiner Display Area (HUD Can Be Activated.) Inspection Procedure 6: Part Of Information Is Not Displayed Correctly In The Combiner Display Area (HUD Can Be Activated.)
- Inspection Procedure 7: Auto Light Control Function Does Not Work
- Inspection Procedure 8: Brightness Decreases
- Data List Reference Table
- Special Function Table
- HUD
- HUD Switch