Check At Ecu Terminal

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Terminal No.	Terminal code	Check item	Check condition	Normal condition
1 to 5	-	-	-	-
6	CANH	CAN H	-	-
7 to 9	-	-	-	-
10	IG	ECU power supply (Ignition switch: IG1)	Ignition switch: ON	9 - 16 V
10	IG	ECU power supply (Ignition switch: IG1)	Ignition switch: OFF	1 V or less
11	-	-	-	-
12	+B	Battery power supply	Always	9 - 16 V
13	GND	Ground (ECU)	Always	1 V or less
14	SW-	Ground (Switch)	Always	1 V or less
15 to 17	-	-	-	-
18	CANL	CAN L	-	-
19	-	-	-	-
20	AN-	Angle adjustment switch (DOWN) input	Angle adjustment switch (DOWN): Operated	1 V or less
20	AN-	Angle adjustment switch (DOWN) input	Angle adjustment switch (DOWN): Not operated	5 V
21	AN+	Angle adjustment switch (UP) input	Angle adjustment switch (UP): Operated	1 V or less
21	AN+	Angle adjustment switch (UP) input	Angle adjustment switch (UP): Not operated	5 V
22	BR-	Angle adjustment switch (-) input	Angle adjustment switch (-): Operated	1 V or less
22	BR-	Angle adjustment switch (-) input	Angle adjustment switch (-): Not operated	5 V
23	BR+	Angle adjustment switch (+) input	Angle adjustment switch (+): Operated	1 V or less
23	BR+	Angle adjustment switch (+) input	Angle adjustment switch (+): Not operated	5 V
24	O/C	Combiner open/close switch input	Combiner open/close switch: Operated	1 V or less
24	O/C	Combiner open/close switch input	Combiner open/close switch: Not operated	5 V