REP-TAT-P-2430-01 Detach the switching device (8-speed, AISIN GA8F22AW) (Cooper Clubman S and JCW)

NOTE: When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!

Preliminary work:

Refer to REMOVING INTAKE PORT
Refer to REMOVING INTAKE SILENCER HOUSING
Refer to REMOVING CROSS CONNECTION
Refer to REMOVING THE FRONT UNDERBODY PROTECTION
Refer to DRAINING THE OIL FROM THE AUTOMATIC TRANSMISSION
Refer to REMOVING FAN COWL WITH ELECTRIC FAN
Detach the transmission oil cooler from the transmission. Refer to REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (EXCEPT COOPER CLUBMAN JCW) or REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (COOPER CLUBMAN JCW) .
Refer to REMOVING THE COVER (OIL PAN) FOR THE SWITCHING DEVICE (GA8G45 / F22AW)
Detach the switching device (GA8G45 / F22AW)
Install the switching device (GA8G45 / F22AW)

Detach all connectors (1).
Detach the connector (2) from the holder.

Courtesy of BMW OF NORTH AMERICA, INC.
Unscrew the bolt (2) and remove the hold-down device.
Detach the temperature sensor (1) from the switching device.
Lay the wiring harness on the transmission toward the top.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (2).
Remove the switching device (1).

Courtesy of BMW OF NORTH AMERICA, INC.