REP-TAT-P-5218-02 Install backrest frame
- Correctly position the rear seat backrest (5).
If necessary, feed in relative cables.
NOTE: Perform the steps on the right and left side. - Tighten the screws (4).TIGHTENING TORQUE SPECIFICATION
Seat frame to backrest frame Screw Replace screw. tightening torque 38 Nm
Correctly attach cable linkage (1) in holders (2) and (3).
Follow-up work
- Install the BACKREST SEAT COVER WITH CUSHION
- Install/replace SIDE AIRBAG
- Install the TRIM at the bottom of the aperture
- Install the REAR PANEL on the front seat backrest
- Install the OUTER COVER on the front seat
- Install the LEVER for seat height adjustment
- Install the STEERING LEVER for backrest adjustment
- Install the COVER for backrest adjustment
- Install INNER COVER
- Install FRONT SEAT
- Install the front STRAP FITTING