11 61 065 Removing and installing/replacing left intake manifold (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 0 200

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work :

Disconnect HIGH-VOLTAGE SYSTEM from power
Observe SAFETY INSTRUCTIONS for working with hybrid vehicles.

Necessary preliminary tasks:

Remove complete front panel.
Remove complete cooling core with condenser. See:
Remove left INJECTION PIPE .

Detach engine ventilation hose (1).

Unscrew nuts (2).

Tightening torque: 11 61 1 AZ.

Fig 1: Identifying Engine Ventilation Hose And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

FIT SPECIAL TOOL 00 0 200 .

Fig 2: Fitting Special Tools For Engine Support

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts on left and right engine support arms.

Raise engine.

Fig 3: Identifying Left And Right Engine Support Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release THROTTLE VALVE (1).

Release screw (2).

Tightening torque: 11 61 2 AZ.

Installation:

Replace all profile seals.

Fig 4: Identifying Throttle Valve And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine and vehicle.

Check intake system for leaks.